S1(config)# interface gi0/1 S1(config-if)# switchport mode trunk S1(config-if)# no shutdown This is the core of "Router-on-a-Stick." We will configure sub-interfaces on a single physical interface. Each sub-interface acts as the default gateway for a specific VLAN. Matlab Codes For Finite Element Analysis M Files
Below is a complete blog post tutorial walking through the configuration, verification, and troubleshooting of this essential networking scenario. Welcome back to the lab series! Today, we are tackling Lab 1.6.2 , a critical milestone for any networking student. This lab moves beyond basic switch configuration and into the realm of Inter-VLAN Routing . Bajirao Mastani Telugu Movierulz Free Online
Check if the sub-interfaces are "up/up" and have the correct IPs.
Based on the standard naming conventions used in Cisco networking education, typically refers to a specific skills integration challenge, most commonly the "Configure Router on a Stick Inter-VLAN Routing" lab (often found in Cisco's CCNA curriculum).
S1(config)# interface fa0/2 S1(config-if)# switchport mode access S1(config-if)# switchport access vlan 20 S1(config-if)# no shutdown The link connecting the Switch to the Router must be a trunk to carry traffic for both VLAN 10 and 20. Let's assume the uplink is GigabitEthernet0/1 .
Here is everything you need to know to complete the lab, including the topology overview, configuration commands, and verification steps. In this lab, we typically have one router (R1), one switch (S1), and a few end devices (PCs) belonging to different VLANs.
Happy Networking!